Selby Furniture Hardware Co. Inc.-The Houdini of Hardware



	Shelf Hardware and Accessories

Shelf Supports

Page2
Move to Page <1> <3> <4>

KTENTI/3
Shelf Magic I (No Visible Means of Support!)
Mount a shelf to the wall (up to 2" thick!) and how it was hung no one can tell! Screw anchors are placed in the wall in 6mm (15/641!) holes and the mounting bracket is affixed to them. The support rod is fixed to the mounting bracket with set screws ( vertically and horizontally adjustable). Holes (12mm diam. x 3-5/81! deep) are drilled into the rear of the shelf to seat the rod. For super- invisibility, a 7/81! wide groove by 3/161! deep may be cut into the shelf back for full concealment.
Load Rating: 2 units-90 Ibs., 3 units-135 Ibs.
Packed in bags each containing one unit: 1 mounting bracket, 1 support rod, 6 screws and 6 plastic screw anchors (100 per box)

K-91309
Shelf Magic II (No Visible means of Support)
For users with 32mm. hole boring machines, Smm. diameter holes are drilled into the side wall. The special-headed screw is inserted into the hole. In the shelf bottom a 20mm hole is drilled 9/16" deep with the center 9mm from the edge of the wood. After the nylon disk is inserted into tne shelf, a downward pressure locks it onto the screw head. Tough nylon in brown or white with steel screw. All machining operations are into the face of the wood, not into the end qrain.
(1 disk and 1 screw per unit)

K-575 576, 577
Shelf Magic III (No Visible Means of Support)
For thicker shelves: 1 ", 1-1/8" or 1-3/16 ' thick Manually Locks and Unlocks With Slide Lever Metal part with locking lever fastens to sidewall with Euro-screw (supplied) into 5mm dia. holes as used in 32mm. boring setups. Nylon dowel/disk is driven into step-hole in the Shelf, with an inner hole 10mm diam. x 25mm long to receive the dowel. Bottom slide-Iever retracts to lock-in shelf.
K-575/25: 1 "shelf
K-576/28: 1-1/8"shelf
K-577/30: 1-3/16"shelf

X-520
Shelf Magic IV (No Visible Means of Support)
Magic Wire Shelf Supports in Six Sizes Drill a series of 1/8" diameter holes x 1/2" deep in the side wall, horizontally separated according to the wire selected and the shelf deptfl MINI series used individually for any hole spacing.
X-520/6+ U: 6-1/4" long
X-520/7 U: 7" long
X-520/7+ U: 7-3/4" long
X-520/9+ U: 9-3/4" long
X-520MINI U: single end for one hole

Attention: Check sample before drilling holes

Shelf supports Move to Page <1> <3> <4>

Shelf Hardware	Lighting Fixtures	Casters & Glides	Drawer Slides	Hinges	Assembly Fittings	Locks & Accessories	Catches
Panel & Grille Retainers	Swivels & Accessories	Stays & Lid Supports	Table Hardware	Wardrobe & PullOuts	Electric Mechanisms	Sleep Systems	Authentic Brass Reproduction Hardware